I know the rule of placement for a standard outlet in a single height tophat is 1/2 the height of the inlet centered on the inlet. How does this change with;
(1) Using a bellmouth
(2) a double height, or higher top-hat separator?
My inlet is a 6" metal duct that transitions to a 4"x10" rectangle. My outlet is a spun bellmouth that I'm going to have to attach to the outlet pipe, as the bellmouth is only about 4" high anyhow. The circumference will be about 22" as that's the dimension on the fiber-barrel that I have for my collection bucket.
Let me know if you need any additional information.
(1) Using a bellmouth
(2) a double height, or higher top-hat separator?
My inlet is a 6" metal duct that transitions to a 4"x10" rectangle. My outlet is a spun bellmouth that I'm going to have to attach to the outlet pipe, as the bellmouth is only about 4" high anyhow. The circumference will be about 22" as that's the dimension on the fiber-barrel that I have for my collection bucket.
Let me know if you need any additional information.