I am setting up Delta 50-851 with a Thien baffle and a Wynn fanged nano filter. The only reference I found of someone else trying this configuration showed unsatisfactory results.
The housing/filter ring has the following dimensions:
diameter: 24"
Height: 10 3/4"
Inlet port is 6" high, square and centered on ring.
Internal cone opening 19"
opening is 5" from bottom of ring/ Thien baffle.
The Wynn filter has a 14" ID.
Most of the conversions I have seen are based on 20" diameter rings.
My first inclination is to remove the internal cone and use a 6" plastic speaker tube bell mouth as an exhaust to the filter.
Any thoughts? Thanks, Woody
Any thought?
The housing/filter ring has the following dimensions:
diameter: 24"
Height: 10 3/4"
Inlet port is 6" high, square and centered on ring.
Internal cone opening 19"
opening is 5" from bottom of ring/ Thien baffle.
The Wynn filter has a 14" ID.
Most of the conversions I have seen are based on 20" diameter rings.
My first inclination is to remove the internal cone and use a 6" plastic speaker tube bell mouth as an exhaust to the filter.
Any thoughts? Thanks, Woody
Any thought?