I can not find the measurements for cutting the recess area on the baffle. From what I read I think you remove a radius of 240 degrees but I do not know how much to remove. Also would it help to install a wall from the input to past where the relief cut starts so as to direct all of the dust to that area? I was thinking that way you could help prevent some of the fine dust from making it back to the discharge tube. I am building a separator lid for a 55 gal barrel with a 6 inch inlet and outlet.
- Welcome to J. Phil Thien's Projects.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Thien Cyclone Separator Lid Discussion / ratio for baffle
January 18, 2009, 12:26:01 PM
I am looking at building a separator lid for a 55 gal barrel with a 6 inch inlet and outlet. However I can not find the ratio for cutting the baffle. Also would it help to install a wall from the input to past where the relief cut starts so as to direct all of the dust to that area. I was thinking that way you could help prevent some of the find dust from making it back to the discharge tube.
Cecil
Cecil
Pages1