Text only | Text with Images

J. Phil Thien's Projects

General Category => Thien Cyclone Separator Lid Discussion => Topic started by: deguacas on May 16, 2009, 04:38:30 PM

Title: Make the cutout for the baffle???
Post by: deguacas on May 16, 2009, 04:38:30 PM
"Measure, and mark 1.25" from the outside edge up on each of the lines you just drew.
      - using a compass, or string, pencil, and nail, draw an arc from the center point, around the long way to each of the 1.125" in marks you just made."

Is it 1.25" ( = to one and one quarter of an inch)? OR:

1.125" ( = to one and one eight of an inch)?

Help please   ???

After a very long time thinking about it, I'm ready to cut this.

Thank you.

JC
Title: Re: Make the cutout for the baffle???
Post by: phil (admin) on May 16, 2009, 07:04:00 PM
1.125"
Title: Re: Make the cutout for the baffle???
Post by: deguacas on May 16, 2009, 07:30:45 PM
 :)
Thank you.

I'll post pictures when it's done.
Text only | Text with Images