I have a Delta 50-866 which I had converted from using the cloth bags to a plastic bag on bottom and a Wynn 9L300NANO filter on top. From the pic's you will see I had to cut the top, put in a base (of MDF) to attach the filter.
I would like to adapt the baffle design to this. What I was thinking is inside at the bottom putting in the bottom design baffle (with the 240 degree cutout) and then at the top adding another mdf round cutout with a 3" opening for a pipe that would go into the Wynn filter.
As you can see from the inside view there already is a cyclone cutout so the baffle bottom would be below that.
This is a 5 hp motor and there is two filters like this (one on each side).
Has anyone adapted to this type of DC or have any lessons learned that I can use.
I would like to adapt the baffle design to this. What I was thinking is inside at the bottom putting in the bottom design baffle (with the 240 degree cutout) and then at the top adding another mdf round cutout with a 3" opening for a pipe that would go into the Wynn filter.
As you can see from the inside view there already is a cyclone cutout so the baffle bottom would be below that.
This is a 5 hp motor and there is two filters like this (one on each side).
Has anyone adapted to this type of DC or have any lessons learned that I can use.