News:

SMF - Just Installed!

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Maschinot

#1
Woodworking / BT3K blade alignment block question
February 04, 2021, 01:10:05 PM
After years of dis-use, I'm ready to tune up/crank up my old BT3000.
Looking at the alignment block article, I'm unclear as to how to use the bolt/dowel configuration.
I can't see how the indicator is attached to the block.
Then again I'm only on my 3rd cup of coffee.
Help?
Thanks!