Hi All,
Thanks for all of your input. I'm going to trash (pun) the trash can lid collector/baffle I originally made, and which fails missrably.
I am using a Harbor Freight 2HP unit with a secondary plastic bag and Wynn filter.
In that light, I am planning a flat bid and top hat design that does not extend into my 30 gal metal trash can. About 28" diameter.
I am planing a roughly 12.5" high collector. it will again have 5" lead in and out metal ducting. I found a diagonal 6.25 X 6.25 inlet to put by the slot. It will direct the intakes dust against the smooth sides of the collector.
Anyone want to make a sketch for me to follow????
Do you think 2" between the bottom of inlet and the baffle is enough clearence?
How deep(long) should I make the secondary pick up? In other words clearance from the top of the baffle?
Your advice is most valued and appreciated.
Jeff
Thanks for all of your input. I'm going to trash (pun) the trash can lid collector/baffle I originally made, and which fails missrably.
I am using a Harbor Freight 2HP unit with a secondary plastic bag and Wynn filter.
In that light, I am planning a flat bid and top hat design that does not extend into my 30 gal metal trash can. About 28" diameter.
I am planing a roughly 12.5" high collector. it will again have 5" lead in and out metal ducting. I found a diagonal 6.25 X 6.25 inlet to put by the slot. It will direct the intakes dust against the smooth sides of the collector.
Anyone want to make a sketch for me to follow????
Do you think 2" between the bottom of inlet and the baffle is enough clearence?
How deep(long) should I make the secondary pick up? In other words clearance from the top of the baffle?
Your advice is most valued and appreciated.
Jeff