An alternate solution, which I have, is to have lines, pipes, whatever, running from each machine TO the DC, and swap them out at the DC, rather than dragging hose around. All depends on your shop layout.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: phil (admin) on September 05, 2009, 07:01:09 PMAgreed! I'm considering re-doing my Cyclopvac, to make it a smaller diameter, and I was going to just see how tight I could bend plexi....
Nice work.
We need a source for clear bins for these. I've found a few, but they are intended for food service and they are soooo expensive.