So I am starting this with words and hope that can be sufficient because I am not a CAD guy and my drawing skills, well, lets just say 1st grade is where I stalled out!
So, imagine the typical rig that started this page. I have only ever seen the location of the suction port right in the middle and of a similar diameter to the hose. I have stripped a shop vac I obtained uber-cheap from craigslist for this project.
Do you fine folks think that if I build the baffle tall enough to allow the remains to sit right on top with the filter protruding down the middle everything would be okay and functional as a self-contained device?
So, imagine the typical rig that started this page. I have only ever seen the location of the suction port right in the middle and of a similar diameter to the hose. I have stripped a shop vac I obtained uber-cheap from craigslist for this project.
Do you fine folks think that if I build the baffle tall enough to allow the remains to sit right on top with the filter protruding down the middle everything would be okay and functional as a self-contained device?