Author Topic: Long Ranger Remote Starter Replacement and Upgrade  (Read 9150 times)

retired2

  • Hero Member
  • *****
  • Posts: 561
    • View Profile
Re: Long Ranger Remote Starter Replacement and Upgrade
« Reply #30 on: October 31, 2017, 06:20:18 PM »
Here is my version of retired2's ingenious box with only a few minor modifications.  This was an enjoyable build and best of all, it works like a charm.  Note: Even though I used blue insulated spade terminals, the wires (other than the input to the dry switch) are all 12 gauge - solid to the outlet and stranded elsewhere.  Please reply with any observations or critiques.  Thanks.

Nice job Walter.  It looks remarkably familiar!

I assure you it will outlast 10 Long Rangers!

militarybrat

  • Newbie
  • *
  • Posts: 3
    • View Profile
    • Email
Re: Long Ranger Remote Starter Replacement and Upgrade
« Reply #31 on: December 05, 2017, 11:11:30 AM »
Well guys I am a master electrician nice work retired 2. I do mine old school I use a magnetic motor starter with 120 volt coil. Control wiring all machines to their start button. Turn machine on dust collector comes on off is off. My machines are all single phase either 120 or 220. I built lots of control panels and fixed them what i found is to keep it simple stupid. Simple motor starter with simple wiring works best over the long haul by eliminating any electronics and maintenence is  minimal. Don't forget to add single pole switch for turning dust collector on without other machines starting.

There is single phase 120/ 220 that are commonly called A and B phase (even# breakers and odd # breakers) all A phase will NOT short to other A phase breakers same with B phase.

3 phase is A B C same rules apply.

militarybrat

  • Newbie
  • *
  • Posts: 3
    • View Profile
    • Email
Re: Long Ranger Remote Starter Replacement and Upgrade
« Reply #32 on: December 05, 2017, 02:16:04 PM »
Thanks retired 2 ya got my brain working. Gonna draw up some control wiring for shop dust collector. Gonna use electric solinoid to open blast gates one for each gate (default closed). Turn machine on blast gate opens DC starts life is good all easy analog controls. Thinking 24 volt ac for coils in relays that way no voltage wire like cat 5 can be run.120volt to 24 volt ac transformer is a door bell transformer. A single 120 v circuit for selonoids controlled by relays Square D 6 pin ice cube relays. Nice task for me right now.

retired2

  • Hero Member
  • *****
  • Posts: 561
    • View Profile
Re: Long Ranger Remote Starter Replacement and Upgrade
« Reply #33 on: December 05, 2017, 04:02:03 PM »
Thanks for the compliment, "militarybrat".  I don't know if you noticed reply 18 from TX-Lenador.  There is a PDF file at the bottom of that post that contains his schematic for turning on the separator and also opening the blast gate.  I'm not sure if he ever built it or not, so it might not be tested.